Metal Extrusion Machine Common Problem

Metal Extrusion Machine common problem

Metal extrusion machine in the aluminum metal extrusion machine, which is one of the types of metal extrusion machine, but also one of the products on the site, so its understanding and understanding, it can be said is imperative. Moreover, this is for us, but also can benefit from, to understand the different types of metal extrusion machine. So the next, may wish to have been based on the front, continue to go on, so that you can also achieve the above objectives.

  1. Aluminum metal extruder tonnage size, how to know?

    Aluminum metal extrusion machine tonnage size, you want to know, you can see the metal extrusion machine squeeze the beam on the label, or the initial interface of the console, the above will have a corresponding description. However, we need to know is that even the same type of aluminum metal extrusion machine, which is also able to squeeze different specifications of the cast rod, and not just can only be one.

    2. What are the common problems with aluminum metal extruders during use? In addition, its price, mainly with what?

    Aluminum metal extrusion machine, in the course of the use of the problems often occur, there is a sudden stop running, as well as some mechanical or other aspects of the fault, so in these two, we should pay attention, can not be taken lightly The In addition, the price of this kind of metal extruder, in general, mainly with the manufacturer, specifications, models, and the use of requirements, so, should be taken into account, there can be no omissions.

    3. Aluminum alloy extruder in the heating tube, the reason for its easy to damage, what?

    Aluminum metal extrusion machine in the heating pipe, if it is easy to damage, then the specific reasons, mainly in the following few: First, the heating tube material selection is not appropriate, or material quality is not qualified; Second, Heating pipe production process, the production process problems, or its improper design, such as the pipe wall is too thin; the third is the heating pipe and the gap between the mold is too large, resulting in its dry and damaged.

      On the metal extrusion machine this machine equipment, I believe that through the previous study, we can come to gradually understand and understand the machinery and equipment, at the same time, you can also continue to increase their knowledge in this area. So, since we are good for all of us, then, may wish to continue to go on, so that you can also promote the product learning process, and then, so that we continue to have a new harvest.